LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Evaporator Tube Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cap or tape from the rear evaporator tube and evaporator.
  2. Install a new O-ring to the evaporator tube. Refer to O-Ring Replacement .
    3. Fig 1: Accumulator Hose Bracket & Rear Evaporator Tube
    GM621747Courtesy of GENERAL MOTORS CORP.
  3. Position the rear evaporator tube with the accumulator hose bracket and install the assembly to the evaporator.
    4. Fig 2: Accumulator Hose, Evaporator & Bolt
    GM621748Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the bolt which secures the accumulator hose to the evaporator.

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

  5. Remove the cap or tape from the front evaporator tube.
  6. Install a new O-ring to the evaporator tube. Refer to O-Ring Replacement .
    7. Fig 3: Rear Evaporator Tube & Bolt
    GM621746Courtesy of GENERAL MOTORS CORP.
  7. Install the bolt which secures the front evaporator tube to the rear evaporator tube.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    8. Fig 4: Heater Pipe Bracket & Cowl
    GM621749Courtesy of GENERAL MOTORS CORP.
  8. Install the heater pipe bracket to the cowl stud.
  9. Install the heater pipe bracket retaining nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  10. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical.
  11. Install the battery heat shield. Refer to Battery Heat Shield Replacement in Engine Electrical.
  12. Install the battery. Refer to Battery Replacement in Engine Electrical.
  13. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  14. Leak test the fittings of the component using J 39400-A  . See Special Tools and Equipment .
scientia non olet · About LEMON Manuals