LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Compressor Mounting Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Block Compressor Mounting Bracket & Stud
    GM174359Courtesy of GENERAL MOTORS CORP.
  1. Install the compressor mounting stud to the engine block.
  2. Install the compressor mounting bracket onto the compressor mounting stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the compressor bracket mounting bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    4. Fig 2: Compressor Drive Belt Tensioner & Compressor Mounting Bracket
    GM299792Courtesy of GENERAL MOTORS CORP.
  4. Install the compressor drive belt idler pulley to the compressor mounting bracket.

    Tighten:  Tighten the compressor drive belt idler pulley to 50 N.m (37 lb ft).

  5. Install the compressor drive belt tensioner to the compressor mounting bracket.

    Tighten:  Tighten the compressor drive belt tensioner to 25 N.m (18 lb ft).

  6. Install the compressor. Refer to Compressor Replacement .
scientia non olet · About LEMON Manuals