LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Clutch Rotor and/or Bearing Replacement (V-7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. Refer to Compressor Replacement .
    2. Fig 1: View Of Compressor Mounting Fixture
    GM157595Courtesy of GENERAL MOTORS CORP.
  2. Clamp the A/C compressor holding fixture, J 41790-A  in a vise and attach the A/C compressor to the J 41790-A  . See Special Tools and Equipment .
    3. Fig 2: Removing/Installing A/C Rotor/Hub Snap Ring
    GM157223Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal (V7 - Direct Mount) .
  4. Using external snap ring pliers (1), remove the clutch rotor and bearing assembly retaining ring (3).
    5. Fig 3: J 33023-A & Clutch Rotor
    GM157224Courtesy of GENERAL MOTORS CORP.
  5. Place the J 33023-A  on the clutch rotor. See Special Tools and Equipment .
    6. Fig 4: J 41552 & Inner Circle Slots Of Rotor
    GM157225Courtesy of GENERAL MOTORS CORP.
  6. Install the J 41552  down into the inner circle of slots in the rotor. See Special Tools and Equipment .

    Turn the J 41552  clockwise in the slots to engage the puller tangs with the rotor. See Special Tools and Equipment .

  7. Hold the J 41552  in place and use a wrench to turn the center forcing screw against the J 33023-A  to remove the clutch rotor and bearing assembly. See Special Tools and Equipment .
scientia non olet · About LEMON Manuals