LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Resistor & Wiring Harness Electrical Connector
    GM295302Courtesy of GENERAL MOTORS CORP.
  1. Remove the front floor kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
  2. Remove the cover from the I/P electrical center.
  3. Remove the BLO MOT MaxiFuse® #49 from the I/P electrical center.
  4. Remove the RH lower I/P insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
  5. Disconnect the wiring harness electrical connector from the blower motor resistor.
    6. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the blower motor resistor electrical connector from the blower motor.
    7. Fig 3: Blower Motor Resistor & HVAC Module
    GM295304Courtesy of GENERAL MOTORS CORP.
  7. Loosen the blower motor resistor forward retaining screws (nearest the dash mat) approximately 5 mm (0.197 in).

    The resistor is slotted at the forward retaining locations.

  8. Remove the resistor rear retaining screw.
  9. Tilt down the rear of the resistor; use care to not damage the portion of the resistor which fits up into the HVAC module.
  10. Remove the blower motor resistor from the vehicle.
  11. Inspect the condition of the blower motor resistor seal. Replace if necessary.
scientia non olet · About LEMON Manuals