LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1546 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor
    GM295331Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor to the HVAC module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the blower motor retaining screws.

    Tighten:  Tighten the screws to 1.7 N.m (15 lb in).

  3. Connect the blower motor cooling tube to the HVAC module.
    4. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  4. Connect the blower motor electrical connector.
  5. Install the I/P lower insulator panel - RH. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals