Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Center Air Outlet & Hazard Warning Switch

Courtesy of GENERAL MOTORS CORP.

Install the hazard warning switch to the center air outlet.
Align the switch to the rear of the air outlet, then push to secure the switch.

Fig 2: Underside Trim Pad & Center Air Outlet

Courtesy of GENERAL MOTORS CORP.

Install the air outlet into position on the upper trim pad.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws retaining the center air outlet to the trim pad.
Tighten: Tighten the screws to 1.7 N.m (15 lb in).

Fig 3: Hazard Warning Switch Button

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Align the button to the switch, then push to secure.

Install the hazard warning switch button.

Fig 4: Upper Trim Pad & Air Distribution Duct

Courtesy of GENERAL MOTORS CORP.

Install the air distribution duct into position on the upper trim pad.
Insert the duct retaining tabs into the trim pad slots.
Install the screws retaining the air distribution duct to the trim pad.
Tighten: Tighten the screws to 1.8 N.m (16 lb in).
Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.