LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Engine Cooling System -- 5.7L) >> Repair Instructions >> Fan Shroud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fan Shroud
    GM339969Courtesy of GENERAL MOTORS CORP.
  1. Install the fan shroud.
  2. Raise the vehicle.
    3. Fig 2: Radiator Outlet Hose & Clamp
    GM64026Courtesy of GENERAL MOTORS CORP.
  3. Install the radiator outlet hose to the radiator.
  4. Reposition the radiator outlet hose clamp to the radiator using J 38185  . See Special Tools and Equipment .
    5. Fig 3: Cooling Fan Electrical Connectors
    GM672687Courtesy of GENERAL MOTORS CORP.
  5. Install the forward lamp harness to the retaining clips on the fan shroud.
  6. Connect the cooling fan electrical connectors.
    7. Fig 4: Radiator Inlet Hose
    GM64025Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Install the radiator inlet hose to the radiator.
  9. Reposition the radiator inlet hose clamp to the radiator using J 38185  . See Special Tools and Equipment .
  10. Install the radiator support. Refer to Radiator Support Replacement .
  11. Fill the cooling system. Refer to Draining and Filling Cooling System .
scientia non olet · About LEMON Manuals