Filling Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Close the radiator drain cock.
Tighten: Tighten the radiator drain cock to 2 N.m (18 lb in).
- Lower the vehicle.
- Slowly fill the cooling system with a 50/50 coolant mixture. Refer to Capacities - Approximate Fluid in General Information.
- Install the coolant pressure cap.
- Start the engine.
- Run the engine at 2,000-2,500 RPM until the engine reaches normal operating temperature.
- Allow the engine to idle for 3 minutes.
- Shut the engine off.
- Allow the engine to cool.
- Top off the coolant as necessary.
- Inspect the concentration of the engine coolant using the J 26568 . See Special Tools and Equipment .
- Rinse away any excess coolant from the engine and the engine compartment.
- Inspect the cooling system for leaks.
NOTE:
The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
Use a 50/50 mixture of DEX-COOL antifreeze and deionized water.