Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Removal of the intake manifold is NOT required to service the coolant air bleed pipe, but is required to service the coolant air bleed pipe covers and/or gaskets.

Fig 1: Coolant Air Bleed Pipe, Studs & Gaskets

Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold, if required. Refer to Intake Manifold Replacement in Engine Mechanical - 5.7 L.
Remove the coolant air bleed hose from the throttle body, if required.
Remove the coolant air bleed pipe studs (1).
Remove the coolant air bleed pipe (2) with gaskets (3).

Fig 2: Coolant Air Bleed Pipe Covers, Bolts & Gaskets

Courtesy of GENERAL MOTORS CORP.

Remove the coolant air bleed pipe cover bolts (1), if required.
Remove the coolant air bleed pipe covers (2) with gaskets (3), if required.

Fig 3: View Of Air Bleed Pipe Sealing Gasket

Courtesy of GENERAL MOTORS CORP.

Remove the gaskets from the coolant air bleed pipe and covers. Discard the gaskets.

Fig 4: Coolant Air Bleed Hose & Pipe

Courtesy of GENERAL MOTORS CORP.

Remove the coolant air bleed hose (2) from the pipe (1).
Clean and inspect the coolant air bleed pipe. Refer to Coolant Air Bleed Pipe Cleaning and Inspection in Engine Mechanical - 5.7 L.