LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1543 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid, TCC Solenoid, and Wiring Harness >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of TCC Solenoid & Wiring Harness
    GM71463Courtesy of GENERAL MOTORS CORP.
  1. Install the wiring harness and TCC solenoid assembly with a new O-ring seal to the transmission.
  2. Install the pass-through electrical connector to the transmission case.
    3. Fig 2: View Of TCC Solenoid Bolts & Valve Body Bolts
    GM298139Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the valve body bolts which retain the internal wiring harness and install the TCC solenoid retaining bolts.

    Tighten: 

    • Tighten the control valve body retaining bolts to 11 N.m (97 lb in).
    • Tighten the TCC solenoid retaining bolts to 11 N.m (97 lb in).

    4. Fig 3: Locating Pressure Control Solenoid & Retainer
    GM298162Courtesy of GENERAL MOTORS CORP.
  4. Install the pressure control solenoid.

    Ensure that the electrical tabs are facing outboard.

  5. Install the pressure control solenoid retainer and retaining bolt.

    Tighten:  Tighten the pressure control solenoid retaining bolt to 11 N.m (97 lb in).

    6. Fig 4: View Of TCC PWM Solenoid & Retainer
    GM298154Courtesy of GENERAL MOTORS CORP.
  6. Install the TCC PWM solenoid to the control valve body.
  7. Install the TCC PWM solenoid retainer.
    8. Fig 5: Identifying Valve Body Electrical Connections
    GM181573Courtesy of GENERAL MOTORS CORP.
  8. Connect the internal wiring harness electrical connectors to the following components:
    • Transmission fluid pressure switch (1)
    • 1-2 shift control solenoid (2)
    • 2-3 shift control solenoid (3)
    • Pressure control solenoid (4)
    • TCC PWM solenoid (5)
    • 3-2 control solenoid (6)
  9. Install the 1-2 accumulator. Refer to Accumulator Assembly, Spacer Plate, and Gaskets .
    10. Fig 6: View Of Transmission Harness 20-Way Connector
    GM173661Courtesy of GENERAL MOTORS CORP.
  10. Connect the transmission harness 20-way connector to the transmission pass-through connector.

    Align the arrows on each half of the connector and insert straight down.

  11. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
  12. Lower the vehicle.
  13. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals