Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Brake Fluid Irritant Caution in Cautions and Notices.

NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.

Remove the master cylinder from the vehicle. Refer to Master Cylinder Replacement .
Secure the master cylinder in a vise. Do not clamp the master cylinder body, secure only at the flange.

Fig 1: Removing Brake Fluid Level Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the brake fluid level sensor. Using needle nose pliers, carefully depress the retaining tabs on the end of the brake fluid level sensor (1) and press the sensor through the reservoir to remove.

Fig 2: Removing/Installing Reservoir Retaining Pins

Courtesy of GENERAL MOTORS CORP.

Carefully tap out the reservoir retaining pins.
Remove the reservoir from the master cylinder by pulling the reservoir straight up and away from the cylinder.
Remove the seals from the master cylinder.