Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Brake Fluid Irritant Caution in Cautions and Notices.

NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.

Fig 1: View Of Brake Fluid Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (1) from the brake fluid level sensor.

Fig 2: Brake Pipes To Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Disconnect the brake pipes from the master cylinder.

IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.

Plug the open brake pipe ends.

Fig 3: View Of Master Cylinder & Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Remove master cylinder mounting nuts.
Remove the master cylinder from the vehicle.
Drain the master cylinder reservoir of all brake fluid.