Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Remove the instrument panel knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages, and Console.

Fig 1: Accelerator Pedal Position Sensor & Brake Apply Sensor

Courtesy of GENERAL MOTORS CORP.

Disconnect the accelerator pedal position sensor (1) and brake apply sensor (2).

Fig 2: Isolation Mat To Brake Pedal

Courtesy of GENERAL MOTORS CORP.

Remove the retainer, washer, brake booster pushrod, and brake pedal pin from the brake pedal.
Reposition the isolation mat by cutting a small slit in the mat.

Fig 3: Brake Pedal To Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the brake pedal pivot bolt and nut.
Remove the brake pedal from the mounting bracket.