LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1540 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Hose To Brake Caliper
    GM63952Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install NEW copper brake hose gaskets.
  1. Assemble the NEW copper brake hose gaskets, and the brake caliper inlet fitting bolt to the brake hose.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake hose and the brake caliper inlet fitting bolt to the brake caliper.

    Tighten:  Tighten the brake caliper inlet fitting bolt to 45 N.m (33 lb ft).

    3. Fig 2: Brake Hose To Hose Bracket
    GM171920Courtesy of GENERAL MOTORS CORP.
  3. Install the brake hose to the hose bracket. Ensure that the hose is not kinked or twisted.
  4. Install the retainer onto the brake hose fitting at the bracket.
    5. Fig 3: Brake Pipe Fitting To Brake Hose
    GM171915Courtesy of GENERAL MOTORS CORP.
  5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
  6. Connect the brake pipe fitting to the brake hose:
    • Use a backup wrench on the hose fitting.
    • Do not bend the bracket or pipe.

      Tighten:  Tighten the brake pipe fitting to 18 N.m (13 lb ft).

  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals