LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount-To-Engine Mount Bracket & Nuts
    GM651864Courtesy of GENERAL MOTORS CORP.
  1. Remove the front suspension crossmember. Refer to Crossmember Replacement - Front Suspension in Front Suspension.
  2. Remove the engine mount-to-engine mount bracket nut.
  3. Remove the engine mount (left side shown, right side similar).
  4. Remove the engine mount heat shield from the engine mount, if necessary.
scientia non olet · About LEMON Manuals