LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of A/C Drive Belt Routing
    GM651861Courtesy of GENERAL MOTORS CORP.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  2. Install a breaker bar with hex-head socket to the air conditioning (A/C) drive belt tensioner bolt.
  3. Rotate the A/C drive belt tensioner clockwise in order to relieve tension on the drive belt.
  4. Remove the A/C drive belt from the pulleys.
  5. Slowly release tension on the A/C drive belt tensioner.
  6. Remove the breaker bar and socket from the A/C drive belt tensioner bolt.
  7. Clean and inspect the drive belt surfaces of the pulleys.
scientia non olet · About LEMON Manuals