LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement - Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C Drive Belt Idler Pulley
    GM289960Courtesy of GENERAL MOTORS CORP.
  1. Install the idler pulley bolt.
  2. Install the A/C drive belt idler pulley bolt until snug.
    IMPORTANT: Ensure that the idler pulley is fully seated against the shoulder on the bracket before tightening the bolt.
  3. Install the A/C drive belt. Refer to Drive Belt Replacement - Air Conditioning .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the A/C drive belt idler pulley bolt.

    Tighten:  Tighten the A/C drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals