LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> Off-Vehicle Repair Instructions - Part 1 >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator Tube
    GM639837Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator from the tube.
  2. Remove the oil level indicator tube bolt from the right cylinder head.
  3. Remove the oil level indicator tube from the engine block.
    4. IMPORTANT: Inspect the O-ring seal for cuts or damage. The O-ring seal may be used again if it is not cut or damaged.
  4. Remove the O-ring seal from the tube, if required.
scientia non olet · About LEMON Manuals