LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> Off-Vehicle Repair Instructions - Part 1 >> Clutch Pilot Bearing Removal >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

J 43276  Clutch Pilot Bearing Remover

    Fig 1: Clutch Pilot Bearing & J 43276
    GM353275Courtesy of GENERAL MOTORS CORP.
    NOTE: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
  1. Remove the clutch pilot bearing using the J 43276  .
    1. Install the J 43276-1 into the clutch pilot bearing.
    2. Using a wrench, secure the J 43276-1.
    3. Insert the J 43276-2 into the J 43276-1.
    4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
    5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
    6. Remove the J 43276-1 from the tool body.
    2. Fig 2: Pilot Bearing
    GM63195Courtesy of GENERAL MOTORS CORP.
  2. Discard the pilot bearing.
scientia non olet · About LEMON Manuals