Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Push-In Retainers At Weatherstrip To Lock Pillar

Courtesy of GENERAL MOTORS CORP.

Remove the push-in retainers securing the weatherstrip to the lock pillar.
Pull the weatherstrip with its retainer from the lock pillar weatherstrip retainer.

Fig 2: Removing/Installing Weather-Strip Retainers

Courtesy of GENERAL MOTORS CORP.

Remove the push-in retainers (1,2) securing the forward end of the weatherstrip to the reveal molding and the hinge pillar.
Pull the weatherstrip with it's retainer from the reveal molding.

Fig 3: Weatherstrip Side Retainer

Courtesy of GENERAL MOTORS CORP.

Remove the weatherstrip.
Clean the surface of old sealant material.