LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Stationary Window System) >> Repair Instructions >> Weatherstrip Replacement (Coupe and Convertible) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the driver and passenger side doors.
  2. Remove the roof lift off panel (coupe) or lower the top (convertible).
    3. Fig 1: Windshield Weatherstrip To Windshield Frame
    GM71174Courtesy of GENERAL MOTORS CORP.
  3. Remove the push in retainers from the lower corners of the weatherstrip.
  4. Remove the upper LH/RH corner screws from the weatherstrip on the (convertible model).
    5. Fig 2: Rear Edge Of Weatherstrip To Windshield Upper Retainer Screws
    GM71173Courtesy of GENERAL MOTORS CORP.
  5. Peel the rear edge of the weatherstrip forward to expose the windshield upper retainer screws.
  6. Remove the upper center retainer screws.
  7. Remove the weatherstrip with upper retainer.
  8. Clean the surface of old sealant material.
scientia non olet · About LEMON Manuals