Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Roof & Windshield Header

Courtesy of GENERAL MOTORS CORP.

Apply a 100 mm (4 in) long bead of sealant GM P/N 12345097, or equivalent, across the seam where the roof and windshield header meet.
Install the reward end of the side reveal molding over the lock pillar upper molding.

Fig 2: Applique To Filler Panel

Courtesy of GENERAL MOTORS CORP.

Align the applique to the slot (2) in the filler panel (1).

Fig 3: Side Reveal Molding Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Loosely install the side reveal molding screws.
Tighten the screws in sequence (1-6), starting in the center as illustrated.
Tighten: Tighten the side reveal molding screws to 2.5 N.m (22 lb in).
Apply sealant, install the weatherstrip retainer, the blow out clip, and the weatherstrip. Refer to Weatherstrip Side Retainer Replacement (Coupe and Convertible) or Weatherstrip Side Retainer Replacement (Hardtop) .