Defogger Indicator Always On
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Defogger Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Defogger Schematics Connector End View Reference: Stationary Windows Connector End Views |
|||
| 1 | Did you perform the Defogger Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Defogger |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Test the secondary rear defogger switch signal circuit of the HVAC Control Module for short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the HVAC Control Module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 |
IMPORTANT:
Perform the set up procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the HVAC Control Module. Refer to HVAC Control Module Replacement
in HVAC Systems - Manual. Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |