Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
A minimum of 2 mm (0.08 in) of foam sealing tape must extend beyond the edge of the retainer to prevent water leaks.
- Apply foam sealing tape to a reusable retainer.
- Apply a bead of sealer GM P/N 12345739 Canadain P/N 10953541 across the front of the window blow out clip above the screw hole as shown in the illustration.
- Install the clip to the retainer aligning the clip to the front hole in the retainer.
- Apply a bead of sealer GM P/N 12345739 Canadain P/N 10953541 across the full length of the back of the retainer outside the screw holes as shown in the illustration.
- Position the retainer to the marks made before removal.
- Install the forward screw aligning the retainer fore and aft.
- Install the remaining screws.
Tighten: Tighten the side weatherstrip retainer screws to 3 N.m (27 lb in).
- Apply a bead of sealer GM P/N 12345739 Canadain P/N 10953541 to the ends of the retainer and install the side weatherstrip. Refer to Weatherstrip Replacement - Lift Off Panel .
- Install the roof panel.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.