Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a 6.0 X 40 mm (0.25 X 1.5 in) bead of sealer GM P/N 12345739 Canadain P/N 10953541 to the front and rear corners of the retainer as shown in the illustration.
- Apply the bead of sealer to the roof.
- Apply the bead of sealer to the retainer.
- Apply the bead of sealer to the ends of the retainer.
- Remove the protective backing from the foam tape on the ends of the new weatherstrip, or install two sided tape 3M™ P/N 06377 or equivalent to the ends of a reused weatherstrip.
- Install the weatherstrip into the retainer using a nylon spatula or your fingers. Start at the forward edge and work rearward.
- Install the screws at the ends of the weatherstrip. Hold the weatherstrip to prevent the weatherstrip from rotating.
Tighten: Tighten the side weatherstrip screws to 3 N.m (27 lb in).
- Install the roof panel.
IMPORTANT:
Do not touch the adhesive backing on the new weatherstrip.
NOTE:
Refer toFastener Notice in Cautions and Notices.