Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: #5 Bow Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Install the #5 bow weatherstrip.

Fig 2: Weatherstrip To #5 Bow

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts to the ends of the weatherstrip.
Tighten: Tighten the nuts to 4 N.m (35 lb in).
Install the protective pads to the weatherstrip nuts.
Install the protective pads to the ends of the bow.
Reposition the folding top to the original position.