Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the latch to the roof panel.
- Install the bolts to the latch.
Tighten: Tighten the roof rear latch bolts to 10 N.m (89 lb in).
- Install the latch cover and attaching screws.
Tighten: Tighten the roof rear latch cover screws to 3 N.m (27 lb in).
- Install the roof lift off panel.
- Adjust if necessary. Refer to Roof Lift Off Panel Adjustment .
NOTE:
Refer to Fastener Notice in Cautions and Notices.