LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Roof Lift Off Panel Front Latch Handle Striker >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Bolts At Striker
    GM63754Courtesy of GENERAL MOTORS CORP.
  1. Align the striker with the marks made before removal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the striker attaching bolts.

    Tighten:  Tighten the roof front latch handle striker bolts to 10 N.m (89 lb in).

    3. Fig 2: Latch Cover To Roof Panel
    GM63742Courtesy of GENERAL MOTORS CORP.
  3. Install the upper and side garnish moldings. Refer to Windshield Upper Garnish Molding Replacement in Interior Trim.
  4. Install the sunshade. Refer to Sunshade Replacement in Interior Trim.
    5. Fig 3: Sunroof View
    GM63735Courtesy of GENERAL MOTORS CORP.
  5. Install the roof panel.
  6. Adjust if necessary. Refer to Roof Lift Off Panel Adjustment .
scientia non olet · About LEMON Manuals