LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Folding Top Seal Compression Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seal Compression Panel To Bow
    GM777792Courtesy of GENERAL MOTORS CORP.
  1. Position the seal compression panel to the #1 bow.
    2. Fig 2: Seal Compression Panel
    GM777786Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the seal compression panel on the #1 bow.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

    3. Fig 3: Weatherstrip Screws At Right & Left Front Side Rail
    GM214117Courtesy of GENERAL MOTORS CORP.
  3. Install the screw to the front side rail seal on the #1 bow.

    Tighten:  Tighten the screw to 2 N.m(18 lb in).

scientia non olet · About LEMON Manuals