Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the folding top and place the top on a clean flat surface. Refer to Folding Top Replacement
- Remove the #5 bow weatherstrip. Refer to Weatherstrip Replacement - Folding Top (Front and Center Side Rails) or Weatherstrip Replacement - Folding Top (Rear Side Rail) or Weatherstrip Replacement - Folding Top (Number Five Bow) .
- Drill out the top cover rivets to the bottom of the right and the left rear side rails.
- Pull the top cover from the bottom of the rear side rails and from the ends of the #5 bow.
- Using a grease pencil mark the position of the top cover along the edge where it wraps over the #5 bow to aid in installation.
- Using a pair of needle nose pliers remove the top cover staples from the #5 bow.
- Fold the top cover forward over the #3 bow.
- Remove the headliner screws from the #4 bow.
- Using a pair of needle nose pliers remove the stay pad staples from the #4 bow.
- Turn the top over.
- Remove the glare cover elastic straps screws from the #5 bow.
- Remove the headliner elastic straps screws from the #5 bow.
- Remove the headliner elastic straps screws from the rear side rails.
- Remove the headliner screws from the rear side rails.
- Remove the rear window support elastic strap screws from the #4 bow.
- Remove the #4 bow screws from the main control link bracket.
- Remove the #4 bow.
CAUTION:
Refer to Safety Glasses Caution in Cautions and Notices.