LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Folding Top Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. With an assistant, position the folded top to the vehicle with the top resting on the pillar bracket pin.
    2. Fig 1: Folding Top Pillar Bracket Bolts
    GM784516Courtesy of GENERAL MOTORS CORP.
  2. Align the folding top to the marks made upon removal.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the folding top bolts to the body.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Convertible Top
    GM214136Courtesy of GENERAL MOTORS CORP.
  4. Close and latch the top.
  5. Connect the rear defogger electrical connections.
  6. Install the lock pillar trim panel. Refer to Trim Replacement - Lock Pillar (Upper Convertible) or Trim Replacement - Lock Pillar (Coupe) or Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) in Interior Trim.
  7. Check top for proper operation.
  8. Water test the folding top. Refer to Waterleak Test Preparation in Water Leaks.
scientia non olet · About LEMON Manuals