LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Folding Top Main Control Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the folding top and place the top upside down on a clean flat surface. Refer to Folding Top Replacement .
  2. Remove the following components from the rear side rail.
    1. The headliner screws
    2. The glare cover elastic strap screws
    3. The headliner elastic strap screws
    3. Fig 1: Headliner Screws To #1 Bow
    GM784498Courtesy of GENERAL MOTORS CORP.
  3. Remove the headliner screw from the #1 bow.
    4. Fig 2: Headliner Push-On Retainers To #1 Bow
    GM784499Courtesy of GENERAL MOTORS CORP.
  4. Remove the headlining push-on retainers from the #1 bow.
    5. Fig 3: #2, #3, #4 & #5 Bow To Main Control Link Bracket
    GM311345Courtesy of GENERAL MOTORS CORP.
  5. Remove the main control link bracket screws from the #2 bow (2).
  6. Remove the main control link bracket screws from the #3 bow (3).
  7. Remove the main control link bracket screws from the #4 bow (4).
  8. Using a grease pencil mark the end position of the adjustable link rod as an aid in assembling a new part.
  9. Remove the screw (6) from the end of the main control link rod on the #5 bow (7).
  10. Remove the screw from the main control link on the center side rail.
  11. Remove the screw from the main control link on the front side rail.
    12. Fig 4: Main Control Link
    GM311075Courtesy of GENERAL MOTORS CORP.
  12. Remove the main control link.
scientia non olet · About LEMON Manuals