Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the main control link to the top.
- Install the spacers and the screw attaching the main control link to the front side rail.
Tighten: Tighten the screw to 20 N.m (15 lb ft).
- Install the spacers and the screw attaching the main control link to the center side rail.
Tighten: Tighten the screw to 20 N.m (15 lb ft).
- Adjust the end of the link adjuster (6) rod to match the marked position.
- Install the end screw to the main control link rod on the #5 bow (7).
Tighten: Tighten the screw to 15 N.m (11 lb ft).
- Install the screws to the control link brackets on the #2, 3, and 4 roof bows.
Tighten: Tighten the screws to 13 N.m (9 lb ft).
- Install the headliner push-on retainers to the #1 bow.
- Install the attaching the headliner screws to the #1 bow.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the glare cover to the #5 bow.
Tighten: Tighten the screw to 2 N.m (18 lb in).
- Install the headliner screw to the rear side rail.
Tighten: Tighten the screw to 2 N.m (18 lb in).
- Install the headliner elastic strap screw to the rear side rail.
Tighten: Tighten the screw to 2 N.m (18 lb in).
- Install the folding top. Refer to Folding Top Replacement .
- Reposition the folding top to the original position.
NOTE:
Refer to Fastener Notice in Cautions and Notices.