LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Folding Top Latch Adjustment

Folding Top Latch Adjustment

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Latch Handle At Striker
    GM476795Courtesy of GENERAL MOTORS CORP.
  1. Adjust the latch handle (1) for proper fit, by raising or lowering the striker (3).
    2. IMPORTANT: You should not have to loosen the striker screws.
  2. Use a nylon mallet and a drift to punch the striker (3). Punch upward to loosen the striker or punch downward to tighten the striker.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Inspect the striker screws for proper torque.

    Tighten:  Tighten the striker screws 10 N.m (89 lb in).

    4. Fig 2: Latch Handle Bolts
    GM784478Courtesy of GENERAL MOTORS CORP.
  4. Loosen the latch handle bolts.
    5. IMPORTANT: Assure that the latch handle base is parallel to the striker.
  5. Reposition the latch handle forward or rearward. To avoid squeaks and rattles maintain a minimum of 2 mm (0.08 in) clearance between latch handle and the latch striker.
  6. Tighten the latch handle bolts.

    Tighten:  Tighten the bolts to 13 N.m (10 lb ft).

scientia non olet · About LEMON Manuals