Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Glare Cover Screws To #5 Bow

Courtesy of GENERAL MOTORS CORP.

Rivet the glare cover to the #5 bow.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the glare cover screws to the #5 bow.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the screws attaching the elastic straps to the #5 bow.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Close the stowage lid and latch the top.