LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Folding Roof System) >> Repair Instructions >> Folding Top Front and Center Rail Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front and center rail assembly.
    2. Fig 1: #2, #3, #4 & #5 Bow To Main Control Link Bracket
    GM311345Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the spacers and the screw attaching the center rail (9) to the rear side rail (8).

    Tighten:  Tighten the screw to 19 N.m (14 lb ft).

  3. Install the spacers and the screw attaching the center rail (9) to the balance link.

    Tighten:  Tighten the screw to 23 N.m (17 lb ft).

    4. Fig 2: Main Control Link Screw To Front Side Rail
    GM289895Courtesy of GENERAL MOTORS CORP.
  4. Install the spacers and the screw attaching the main control link to the front side rail.

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  5. Install the spacers and the screw attaching the main control link to the center side rail.

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

    6. Fig 3: #1 Bow Nuts To Front Side Rails
    GM784546Courtesy of GENERAL MOTORS CORP.
  6. Install the nuts attaching the #1 bow (1) to the front side rail.

    Tighten:  Tighten the nuts to 14 N.m (10 lb ft).

    7. Fig 4: Headliner Push-On Retainers To #1 Bow
    GM784499Courtesy of GENERAL MOTORS CORP.
  7. Install the headliner push-on retainers to the #1 bow.
    8. Fig 5: Headliner Screws To #1 Bow
    GM784498Courtesy of GENERAL MOTORS CORP.
  8. Install the headliner screw to the #1 bow.

    Tighten:  Tighten the headliner screw to 2 N.m(18 lb in).

  9. With an assistant install the folding top to the vehicle. Refer to Folding Top Replacement .
  10. Install the front and center side rail weatherstrip retainers. Refer to Weatherstrip Retainer Replacement - Folding Top (Front and Center Side Rail)  or Weatherstrip Retainer Replacement - Folding Top (Rear Side Rail)  Front and center side rail.
  11. Before stapling the top cover to the #1 bow, refer to Folding Top Cover Tension Adjustment - Front .
  12. Reposition the folding top to the original position.
scientia non olet · About LEMON Manuals