Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wiper Motor Crank Arm To Wiper Motor & Park Latch

Courtesy of GENERAL MOTORS CORP.

Install the wiper motor crank arm onto the wiper motor.
Position the park latch 4 - 5 mm (0.16 - 0.20 in) from the park tab.

Fig 2: Wiper Motor Crank Arm Screw

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the wiper motor crank arm screw.
Tighten: Tighten the screw to 15 N.m (11 lb ft).

Fig 3: Installing Wiper Transmission To Wiper Motor Crank Arm

Courtesy of GENERAL MOTORS CORP.

Using the J 39529 , connect the wiper transmission to the wiper motor crank arm. See Special Tools and Equipment .
Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
Inspect the wipers for proper operation.