LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1534 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Drain the washer solvent from the washer solvent container.
    3. Fig 1: Washer Solvent Container Level Sensor Electrical Connector
    GM829207Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the washer solvent container level sensor electrical connector.
    4. Fig 2: Washer Solvent Container At Mounting Studs To Washer Pump
    GM829164Courtesy of GENERAL MOTORS CORP.
  4. Remove the washer solvent container nuts.
  5. Remove the heater hose retention clamp from the mounting stud.
  6. Remove the washer solvent container from the mounting studs to gain access to the washer pump.
    7. Fig 3: Washer Pump Electrical Connector
    GM174219Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the washer pump electrical connector.
  8. Disconnect the washer pump hose.
  9. Remove the washer solvent container from the vehicle.
scientia non olet · About LEMON Manuals