LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Lamp Deflector Replacement - Front Bumper Fascia >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • If the vehicle has the fog lamp option ensure that the fog lamp opening filler has been removed from the fascia deflector.
  • If the vehicle does not have the fog lamp option ensure that the fog lamp opening filler has been installed to the fascia deflector.
    Fig 1: Fascia Lamp Deflector Bolts
    GM63724Courtesy of GENERAL MOTORS CORP.
  1. Position the fascia lamp deflector to the fascia.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fascia lamp deflector to fascia bolts.

    Tighten:  Tighten the fascia lamp deflector bolts to 3 N.m (27 lb in).

  3. Install the fog lamp, if removed. Refer to Fog Lamp Replacement - Front in Lighting Systems.
  4. Install the front fascia close out panel. Refer toClose Out Panel - Front Bumper Fascia Lower  .
scientia non olet · About LEMON Manuals