LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Fascia Retainer Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Fascia Retainer At Bracket Bolts
    GM63707Courtesy of GENERAL MOTORS CORP.
  1. Position the retainer to the upper bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front fascia retainer to bracket bolts.

    Tighten:  Tighten the front fascia retainer bolts to 7 N.m (62 lb in).

  3. Install the front fascia. Refer to Fascia Replacement - Front Bumper  .
scientia non olet · About LEMON Manuals