Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the air deflector and the left and right outer valance. Refer to Air Deflector Replacement - Front Bumper Fascia .
- Remove the fascia to skid bar bolts.
- Remove the fascia to radiator support bolts.
- Remove the fascia lower close out panels. Refer to Close Out Panel - Front Bumper Fascia Lower .
- Remove the wheelhouse panel to fascia bolts.
- Disconnect the fascia harness connector.
- Remove the nuts from the fender reinforcement studs.
- Disconnect the front brake caliper cooling ducts from the fascia. Pull the fascia outward slightly to release the tension between the ducts and the fascia.
- Lower the vehicle.
- Remove fascia upper flange to fascia retainer push-pins and bolts.
- Remove the fascia.
- Remove the fascia grilles from the fascia. Refer to Fascia Grille Replacement .
- Remove the fog lamps from the fascia. Refer to Fog Lamp Replacement - Front .