LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Fascia Grille Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fascia Grille At Front Of The Fascia Opening
    GM721297Courtesy of GENERAL MOTORS CORP.
  1. Install the fascia grille through the front of the fascia opening.
    2. Fig 2: Wiring Harness' Retainer Clips & Fascia Grille
    GM721294Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fascia grille screws.

    Tighten:  Tighten the fascia grille screws to 2 N.m (18 lb in).

  3. Install the clips at the top of the fascia grille (2).
  4. Install the wiring harness' retaining clips (1).
  5. Install the front brake caliper cooling duct. Refer to Brake Caliper Cooling Duct Replacement - Front  .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals