LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Fascia Bracket Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Fascia Bracket Bolts
    GM63710Courtesy of GENERAL MOTORS CORP.
  1. Position the front bumper fascia bracket to the impact bar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front fascia bracket to impact bar bolts.

    Tighten:  Tighten the front fascia bracket bolts to 7 N.m (62 lb in).

  3. Position the front fascia retainer to the front fascia bracket.
    4. Fig 2: Front Fascia Retainer At Bracket Bolts
    GM63707Courtesy of GENERAL MOTORS CORP.
  4. Install the front fascia retainer to fascia bracket bolts.

    Tighten:  Tighten the front fascia retainer bolts to 7 N.m (62 lb in).

  5. Install the front fascia. Refer to Fascia Replacement - Front Bumper  .
scientia non olet · About LEMON Manuals