LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Close Out Panel - Front Bumper Fascia Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Fascia Lower Close Out Panel To Wheelhouse Panel
    GM63701Courtesy of GENERAL MOTORS CORP.
  1. Position the close out panel to the wheelhouse panel and to the fascia.
  2. Install the close out panel to fascia bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the close out panel to wheelhouse panel bolts.

    Tighten:  Tighten the front fascia lower close out panel bolts to 7 N.m (62 lb in).

  4. Install the valance panel.

    Tighten:  Tighten the valance screws to 7 N.m (62 lb in).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals