LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1533 (Bumper System) >> Repair Instructions >> Brake Caliper Cooling Duct Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Cooling Duct At Wheelhouse Panel
    GM63704Courtesy of GENERAL MOTORS CORP.
  1. Insert the brake caliper cooling duct into the opening in the wheelhouse.
  2. Rotate the duct to lock in place.
  3. Reposition the fascia forward and up to gain clearance.
  4. Position the duct over the opening in the fascia.
    5. Fig 2: Front Fascia At Skid Bar Bolts
    GM63693Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the fascia to skid bar bolts.

    Tighten:  Tighten the front fascia to skid bar bolts to 3 N.m (27 lb in).

    6. Fig 3: Front Fascia Lower Close Out Panel To Wheelhouse Panel
    GM63701Courtesy of GENERAL MOTORS CORP.
  6. Install the fascia close out panel. Refer to Close Out Panel - Front Bumper Fascia Lower  .

    Tighten:  Tighten the front fascia lower close out panel bolts to 7 N.m (62 lb in).

  7. Install the wheelhouse to fascia bolts.

    Tighten:  Tighten the wheel house to fascia bolts to 3 N.m (27 lb in).

  8. Lower the vehicle.
  9. Install the fascia to energy absorber bolts.

    Tighten:  Tighten the front energy absorber bolts to 5 N.m (44 lb in).

  10. Install the front license plate/cover.
scientia non olet · About LEMON Manuals