LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1531 (General Information) >> Introduction >> Engine ID and VIN Derivative Location

Engine ID and VIN Derivative Location

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 5.7L Engine Identification Numbers Component View LS1
GM63234Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Engine ID Number, Primary Location
2 Engine ID Number, Secondary Location

The eighth digit of the vehicle identification number (VIN) is the engine code letter, which identifies the engine as a 5.7L V8 (VIN eighth digit: G) (RPO code LS1).

Stick-on labels attached to the engine, laser etching, or stampings in the engine block indicate the engine unit number/build date code.

The engine ID number will be located rear of LH cylinder head or the front part of LH oil pan rail.

Fig 2: 5.7L Engine VIN Derivative Locations Component View LS1
GM289951Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 VIN Derivative, Primary Location
2 VIN Derivative, Secondary Location

The engine is also stamped with a VIN derivative number which will be located in either the primary or secondary location, as shown. For additional information, refer to VIN Derivative .