LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1530 (Body Front End) >> Repair Instructions >> Wheelhouse Filler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Filler Panel To Wheelhouse Panel Bolts
    GM71282Courtesy of GENERAL MOTORS CORP.
  1. Position the filler panel over the wheelhouse panel and behind the fender wheel opening flange.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts attaching the filler panel to the wheelhouse panel.

    Tighten:  Tighten the filler panel to the wheelhouse bolts to 10 N.m (89 lb in).

    3. Fig 2: Fender Wheel Opening To Filler Panel Bolts
    GM71281Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts attaching the fender wheel opening to the filler panel.

    Tighten:  Tighten the fender wheel opening to the filler panel bolts to 2 N.m (18 lb in).

    4. Fig 3: Filler Panel To Frame Rail Bolts
    GM71279Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts attaching the filler panel to the frame rail bolts.

    Tighten:  Tighten the filler panel to the frame rail bolts to 2 N.m (18 lb in).

    5. Fig 4: Filler Panel To Lower Fender Flange Bolt
    GM71280Courtesy of GENERAL MOTORS CORP.
  5. Install the filler panel to the lower fender flange bolt.

    Tighten:  Tighten the filler panel to the lower fender flange bolt to 2 N.m (18 lb in).

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals