LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1530 (Body Front End) >> Repair Instructions >> Hood Latch Striker Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hood Latch Striker & Bolts
    GM71284Courtesy of GENERAL MOTORS CORP.
  1. Position the striker to the mark on the hood.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts attaching the striker to the hood.

    Tighten:  Tighten the striker bolts to 10 N.m (89 lb in).

  3. Close the hood and check alignment. Adjust as necessary.
scientia non olet · About LEMON Manuals