LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1530 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Plenum To Hood Seal
    GM71296Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Remove the plenum to hood seal.
  3. Remove the wiper arms. Refer to Wiper Arm Replacement in Wipers/Washers Systems.
    4. Fig 2: Push-In Retainers At Engine Edge
    GM171177Courtesy of GENERAL MOTORS CORP.
  4. Remove the push-in retainers from the engine edge of the screen.
    5. Fig 3: Washer Hoses At Bottom Side & Windshield
    GM70096Courtesy of GENERAL MOTORS CORP.
    NOTE: Be sure to follow the service procedure when removing the air inlet grille panel. Failure to follow service procedure may cause damage to the air inlet grille panel or the windshield.
  5. Slide the screen down and out from under the edge of the windshield.
  6. Disconnect the washer hoses from the bottom side of the screen.
  7. Remove the air inlet screen.
scientia non olet · About LEMON Manuals