LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1525 (Seat System) >> Repair Instructions >> Seat Replacement (Manual) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sunroof View
    GM63735Courtesy of GENERAL MOTORS CORP.
  1. Protect the interior and/or provide access for seat removal as follows:
    • Tilt the steering wheel full up.
    • Remove the coupe's roof lift off panel to provide additional space for seat removal and/or place a protective cover over the sill plate and door trim panel.
    • Lower the convertible's folding top to provide additional space for seat removal and/or place a protective cover over the sill plate and door trim panel.
    • Place a protective cover over the hardtop's sill plate and door trim panel.
    2. Fig 2: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  2. Position the seat rearward.
  3. Remove the push pins and covers from the front of the adjuster legs.
  4. Remove the nuts from the front of the adjuster legs.
    5. Fig 3: Seat Cushion Frame To Adjuster Bolts
    GM71222Courtesy of GENERAL MOTORS CORP.
  5. Position the seat forward and proceed to step 7. If the seat wont move because the adjuster is inoperative and the rear mounting nuts are not accessible perform the following steps.
    1. Remove the recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
    2. Reach under the front of the seat cushion and cut the seat cushion cover draw string at the front center of the seat.
    3. Reposition the seat cushion cover and foam to access the 4 seat cushion frame to adjuster attaching bolts.
    4. Remove the seat cushion frame to adjuster bolts.
    5. Remove the seat belt harness rosebud clip (drivers seat).
    6. Remove the seat.
    6. Fig 4: Seat Mounting Component View
    GM71215Courtesy of GENERAL MOTORS CORP.
  6. Remove the nuts attaching the rear adjuster legs.
  7. Remove the seat and/or the adjuster(s).
  8. Transfer parts as necessary.
scientia non olet · About LEMON Manuals